DLE-TEST16 : Still a
REGENERATIVE ACCELERATION EFFECT WITH 3 OUTPUT COILS created on february 9, 2013 - JLN
Labs - last update march 18, 2013 All informations and
diagrams are published freely (freeware) and are intended for a private use and a non commercial
use.
Toutes les informations et
schémas sont publiés gratuitement ( freeware ) et sont
destinés à un usage personnel et non commercial I
am very gratefull to Thane C. Heins for his encouragements and
his very helpfull technical support Cliquez ici pour la version FRANCAISE
March 17, 2013
- DLE-TEST16
: Following
the successful tests of CHARGING A BATTERY UNDER LOAD in the DLE-TEST15, here is a new test with
the RAG v1.5 (Regenerative Acceleration Generator) with 3 regenerative
coils (Regen).
In this test, the 1st Regen coil is loaded with 2 high power
LED bulbs (SMD type), the 2nd Regen coil recharge a 12V
Lead battery and the 3rd Regen coil is loaded with 2 high
power LED bulbs (SMD type). The turn speed rate (RPM), the DC
voltage/current at the input and battery voltage/current
parameters are measured in real time while the load are connected
sequentially. he RAG v1.5 is a replication of
the Thane C. Heins' ReGenX of Potential Difference Inc. Canada.
The
2nd and the 3rd Regen coils are placed so as to fully cancel the cogging
torque
produced by the magnetic attraction between the rotor magnets and
the cores of the Regen coils. This cogging torque generates a bad
magnetic drag effect which consumes power.
Below
the setup of the TEST-DLE16 :
A Fluke 123 oscilloscope is used as a data logger for recording
the charging curve of the 12V lead battery (1.3Ah/20HR).
TESTS
RESULTS on the RAG v1.4 :
The REGENERATIVE
ACCELERATION EFFECT is stil present here in this setup. When
the 1st and the 3rd Regen coils are loaded with FOUR LED bulbs
and simultaneously the 2nd Regen coil recharges the 12 V
battery, the RPM speed increases and the power drops at the input.
visits since december 29,2012