The PFT Motor mk2
The Poynting Flow Thruster project
By Jean-Louis Naudin
created on September 11th, 1999 - JLN Labs - Last update September 14th, 1999
I have also conducted some measurements about the mechanical power generated by the PFT-Motor series.
Mechanical output measurement: Experimental setup
Experimental setup : I have used a simple DC motor as a driver and linked on the main PFT Motor shaft . The speed has been measured with an optical tachometer and the electrical power input with two DC multimeters.
TEST RESULTS : The DC motor used is a Graupner Speed400, 6V (model 3321). The electrical power input required for the DC motor has been plotted ( with the orange dotted line ) by measuring the voltage and current at the input with the HV power supply switched OFF. The others curves plotted show the power required by the HV power spply ( 28kV generator ) for obtaining the same speed without the DC motor.
Email : JNaudin509@aol.com
Return to the PFT Motor mk2 page