OUTDOOR Tests of the Lifters
By Jean-Louis Naudin
created on October 10th, 2001 - JLN Labs - Last update Nov 1th, 2001
All informations in this page are published free and are intended for private/educational purposes and not for commercial applications


See : The LIFTER v3.0 - First LAUNCH TEST

The Lifter V3.0 and v4.0 have been tested successfully in open air, in spite of a windy weather, the Lifters have shown a good stability during the hovering.

See the OUTDOOR test video of the Lifter v3.0

To see the videos, the free downloadable RealPlayer is required

Click on the picture above to see the video ( 398 Kb )

See the OUTDOOR test video of the Lifter v4.0

Click on the picture above to see the video ( 551 Kb )

Notes from JL Naudin : It seems interesting to notice that, in spite of the windy weather and the light weight of the Lifters, the hovering phase is stable.

LIFTER v3.0 - First LAUNCH TEST ( Nov 1, 2001 )

The nylon wires which secured previously the Lifter to the base have been removed. Now, the Lifter is guided with a 1 meter fiberglass ramp, so as it is able to slide along it by the mean of a small plastic tube ( see the photos below ).


A small rubber ring is placed at the top to avoid that the Lifter escapes.

TESTS RESULTS :

When the HV power is switch on the Lifter v3.0 goes upward quickly ( in spite of some frictions in the sliding tube ). The Lifter v3.0 remains stable at the top of the ramp ( 1 meter above the wooden table... ) so long as the HV Power Supply is switched on.

See the Test Launch of Lifter v3.0

Click on the picture above to see the video ( 884 Kb )


Email : JNaudin509@aol.com


Return to the Lifters experiments page