||[Lifters] Electrogravity Vs
IMHO, I think that there are some differences between
Antigravity and Electrogravity :
Power requirement :
- Antigravity : It is required a great amount of
power for getting the basic effect,
- Electrogravity : The basic effect can be
obtain with few power.
- Antigravity : The power required for getting
the effect is constant and independant of the total mass
of the spacecraft and its content. So, in this case, the
power generator can be very heavy because its weight is
- Electrogravity : The power is fully dependant
from the total mass of the of the spacecraft. More
weight, more power, but the effect increases while the
altitude increases and thus the craft acceleration upward
can be very fast comparing to a common helicopter which
has a max ceiling.
Newton 3rd law violation :
Antigravity and Electrogravity both violate the Newton
3rd law, BUT, there are some restrictions with the
- Electrogravity : The thrust is only applied on
the atom structure of the main armature ( in the Lifter
this is the aluminum plate ), so, for increasing the
thrust dense material is required. Special equipments are
required for the payload and the onboard team...
- Antigravity : No special equipment is required
for the payload and the onboard team...
Shielding Effects :
- Electrogravity : There is no shielding effect
above and below the craft... The medium flow around the
craft goes downward during the Lift Off like an
- Antigravity : The hull of the spacecraft acts
as a shield Vs the gravity field, there is a shielding
effect above and below the craft. The medium around the
craft is fully repulsed by the hull of the craft.
Secundary Effects :
- Electrogravity : Due to the strong ionization
of the air, ozone and glowing effects are generated
around the craft. There are also a humming and variable
noise during the LiftOff and landing sequence. A plasma
sheet can cover the entire hull of the craft due to the
strong E-Field. The generation of ELF around the craft
can generates some troubles. Strong Electric and magnetic
field can be induced near the craft.
- Antigravity : The craft can be fully black,
translucid and may vanish to an observer due to the
change of the refraction indice of the surrounding
medium. The objects near the craft can be set in motion
due to the local change of the gravity field. There are
also some possible time modification near the craft due
to the local distortion of the spacetime.
Antigravity Vs Electrogravity :
- Electrogravity is the low cost way for the Advanced
Propulsion. It is limited to small crafts and works
better in an atmospherical environment due to help of the
motion of the medium. The effect increases while the
pressure decreases and this works also in the full vacuum
with some special additional features.
- Antigravity is the royal way. There is no limitation,
but, due to some strong secundary effects on the
surrounding, this must be used for big spacecrafts and
this is better for a deep space travel.
Fiction, Anticipation... That is the question,
Main Web site : http://ww.jlnlabs.org
Alternate site : http://jnaudin.free.fr/